How to perform laser leveling
Plow the field when the soil is moist. Dry soil requires a significant increase in tractor power.
Disc or moldboard plow may be needed in hard soil conditions. Disc harrows or tine implements are ideal for secondary workings. All surface residues need to be cut up or removed to aid soil flow from the bucket.
Take a topographic survey of the field, then draw a diagram noting high and low areas.
Using the surveyed readings, establish theof the field.
Based on the field diagram and mean height, determine the strategy to effectively move soil.
Periodically check the laser transmitter for accuracy. All checking and calibration procedures are done at the zero slope reading.
Mount the unit on a tripod at one end of the 60 m range and level it. Set X and Y-axis grade counters at zero. With auto leveling transmitters, turn the transmitter control switch to the AUTO position and wait for the Auto Mode Indicator Lamp to stop flashing.
If the difference between X1 and X2 is less than 6 mm, no adjustment is necessary and the laser can be assumed to give the correct reading.
If the difference is between 6 mm and 38 mm the transmitter then needs to be calibrated and this can be done locally in the field. See calibration of the transmitter.
If the difference is 38 mm or greater the unit must be re-calibrated at an authorized service center. You can not recalibrate it in the field without damage to the unit
The same procedure may be employed by directing the beam onto a wall 60 m away. Instead of having the rodman recording on the staff, make a mark on the wall at X1 and X2 and then draw a line in the center. The beam is then adjusted until it is recorded at the centerline. This system is useful if there is no rodman available or a measuring staff is not available.
The laser-controlled bucket should be positioned at a point that represents the mean height of the field.
For a rotovator, set the cutting blade slightly above ground level (1–2 cm). Drive the tractor in a circular direction from the high areas to the lower areas in the field. When the whole field has been covered in this circular manner, do a final leveling pass in long runs from the high end of the field to the lower end.
In wet areas where there is poor traction or a chance of bogging the tractor, carefully fill the wet areas from the effected edge in a circular motion. Depending on the amount of soil that must be moved, it is possible to level one to two hectares per day using a 50 kW tractor and a two meter wide bucket.
Re-survey the field to make sure the desired level of precision has been attained.
If done properly, laser leveling should not be needed for another 4 years. A light tillage should follow leveling to loosen the soil for planting.